Kawasaki KX250F - Owner's Manual - page 151
150
j
•
Apply a non-permanent locking agent to the front
fork clamp bolts (upper).
•
Tighten the front fork clamp bolts (upper) to the
specified torque.
Tightening Torque
Front Fork Clamp Bolts (Upper):
20 N·m (2.0 kgf·m, 15 ft·lb)
•
Install the front brake caliper to the fork leg, and
tighten the front caliper mounting bolts to the spec-
ified torque.
Tightening Torque
Front Caliper Mounting Bolts:
25 N·m (2.5 kgf·m, 18 ft·lb)
•
Take out wood wedge between the disc brake
pads.
•
Apply high-temperature grease to the grease
seals of the wheel.
•
Install the collars on the left and right side of the
hub.
•
Put the front wheel assembly between the fork
legs, and insert the front brake disc into the front
brake pads.
•
Insert the front axle from the right side of the mo-
torcycle.
•
Tighten the right front axle clamp bolts temporary.
•
Tighten the front axle nut to the specified torque.
Tightening Torque
Front Axle Nut:
78 N·m (8.0 kgf·m, 58 ft·lb)
•
Tighten the left front axle clamp bolts to the spec-
ified torque.
Tightening Torque
Left Front Axle Clamp Bolts:
20 N·m (2.0 kgf·m, 15 ft·lb)
NOTE
○
Tighten the two clamp bolts alternately two times
to ensure even tightening torque.