Kawasaki KX250F - Owner's Manual - page 71
70
j
•
Position the claw on the air cleaner duct clamp
between the projections.
A. Claw
B. Projections
•
Connect the intake air pressure sensor connector,
downstream injector connector and throttle sensor
connector.
•
Install the rear frame with the air cleaner housing
to the throttle body assy.
•
Check the air cleaner duct is installed securely.
•
Tighten the air cleaner duct clamp screw securely.
•
Tighten the throttle body assy holder clamp bolt to
the specified torque.
Tightening Torque
Throttle Body Assy Holder Clamp Screw:
2.0 N·m (0.20 kgf·m, 18 in·lb)
•
Tighten the rear frame mounting bolts to the spec-
ified torque.
Tightening Torque
Rear Frame Mounting Bolts:
34 N·m (3.5 kgf·m, 25 ft·lb)
•
Check the joint lock for deformation and wear.
•
If the joint lock is deformed, replace the fuel hose
with a new one.
•
Apply engine oil to the fuel outlet pipe lightly.
•
Connect the upstream injector connector and in-
take air temperature sensor connector.
•
Insert the fuel hose joints straight onto the delivery
pipes.
•
Push the joint locks until the hose joints clicks.
A. Fuel Hose Joints
B. Joint Locks