Kawasaki KX250F - Owner's Manual - page 69
68
j
•
After removing the throttle body assy, cover the
throttle body assy holder and air cleaner duct with
a clean cloth to protect them from dirt.
•
Clean the throttle body assy.
•
Check the throttle bore at the throttle valve for car-
bon deposits by opening the throttle valve.
•
If any carbon accumulates, wipe the carbon off the
throttle bore and the throttle valve, using a lint-free
cloth penetrated with a high flash-point solvent.
A. Throttle Bore
NOTICE
If dirt gets through into the engine, exces-
sive engine wear and possibly engine dam-
age will occur.
WARNING
Operation with improperly adjusted, incor-
rectly routed, or damaged cables could re-
sult in an unsafe riding condition. Be sure
the control cables are adjusted and routed
correctly, and are free from damage.
•
Lubricate the lower ends of the throttle cables.
•
Install the tip of accelerator cable lower end to the
throttle pulley.
•
Install the accelerator cable so that the position the
claw on the washer.
•
Install the tip of decelerator cable lower end to the
throttle pulley.
•
While holding the decelerator cable bolt, tighten
the cable bolt locknut.
Tightening Torque
Throttle Cable Bolts:
3.0 N·m (0.31 kgf·m, 27 in·lb)
Throttle Pulley Cover Bolts:
3.4 N·m (0.35 kgf·m, 30 in·lb)