Oce im5530 Operator's Manual - General Precautions
10
General Precautions
When installing or moving
Warning
•
This multifunctional digital systems requires 115 V, 20 A, 50/60 Hz electric power.
Do not use a power supply with a voltage other than that specified.
Avoid multiple connections in the same outlet. This could cause a fire or give you an electric shock. If
you are considering increasing the number of outlets, contact an electrician.
•
Always connect this multifunctional digital systems to an outlet with a ground connection to avoid the
danger of fire or electric shock in case of short-circuiting. Contact your service representative for the
details. Be sure to use a 3-conductor, grounded wall outlet.
In areas, except U.S. and Canada, where a 2-pin plug is used, the multifunctional digital systems must
be grounded for safety. Never ground it to a gas pipe, a water pipe, or any other object not suitable for
grounding.
•
Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up and cause a
fire or give you an electric shock.
•
Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
-
Twisting it
-
Bending it
-
Pulling it
-
Placing anything on it
-
Making it hot
-
Situating it near radiators or other heat sources
This could cause a fire or give you an electric shock. If the power cord is damaged, contact your ser-
vice representative.
•
When removing the plug from the outlet, do not pull the power cord. Always hold the plug when remov-
ing it from the outlet. If the power cord is pulled, the wires may become broken and this could cause a
fire or give you an electric shock.
•
Make sure that the ventilation holes are not blocked up.
If the temperature within the multifunctional digital systems becomes too high, a fire could result.
•
The socket outlet should be near the equipment and be easily accessible.
•
Pull out the plug from the outlet more than once a year to clean around the prongs. Accumulating dust
and dirt could cause a fire due to the heat released by electric leakage.