Oce im5530 Operator's Manual - 159

159

5

4

After “Press START button to copy after changing settings.” appears, 

perform the settings for the 1st job and the common settings for all 

jobs.

• Press the [SETTINGS] button to confirm the settings.

• To change the settings, press the [FUNCTION CLEAR] button, and then start the procedure again from step 1.

5

Press the [START] button.

• The scanning of the originals for the 1st job starts.

6

After “Press START button to copy after changing settings.” appears, 

place the originals of the 2nd job. Perform the settings for the 2nd job.

• Note that copying will be performed in the same modes as those of the 1st job if the settings are not changed.

• Press the [SETTINGS] button to confirm the settings.

7

Press the [START] button.

• The scanning of the originals for the 2nd job starts.

• Repeat steps 6 to 7 until all the originals have finished being scanned.

8

After all the originals have finished being scanned, confirm the num-

ber of copies on the menu and change if needed.