Oce im5530 Operator's Manual - page 93

89

3

Specifying both original size and copy size separately

1

Place paper in the drawer(s).

2

Place the original(s).

3

Press the Enlargement/Reduction ([ZOOM...]) button.

4

Specify the original size and copy paper size.

Original size:

 Press the size button representing the same size as that of the set original.

Copy paper size: 

Press the size button representing the desired copy paper size.

e.g.) When LD for the original size and LT for the copy paper size are selected

• The copy paper size can also be set by pressing the drawer button on the touch panel.

• When the original size and copy paper size have been specified, the enlargement/reduction ratio is computed 

and displayed on the touch panel.

• Set other copy modes as required.

When the original or copy paper is a standard size other than LD, LG, LT or ST, you need to register this paper 

size in the selections of the [OTHER] button in advance. See “When a standard size paper other than LD, LG, LT 

and ST-R is set” below for the registration.

5

Press the [START] button.