Zeiss HUMPHREY 720i User Manual - page 12

1-4

INTRODUCTION / INSTRUMENT SETUP

REV. B 02/03 PN 51680-1

HUMPHREY FIELD ANALYZER II -

 i

series

A defect (or scotoma) is categorized as either relative or absolute. A relative defect is an area

that has depressed vision or less than normal sensitivity; an absolute defect is an area where

the perception of light is absent. The point at which the optic nerve enters the retina is referred

to as the blind spot, and is an example of an absolute scotoma.

Some defect patterns are characteristic of certain diseases, a fact which makes visual field

testing a valuable part of the diagnostic process. Furthermore, by having patients repeat the

same tests at later dates, practitioners gain insight into the progression of the disease and the

effectiveness of treatment.

Methods of testing

Over the years, visual field testing devices have varied in size, complexity, and testing

the visual field

methodology. The fundamental premise has remained the same, however; patients must

respond when they see a stimulus.

In kinetic testing, a target of fixed stimulus characteristics is moved into the visual field from a

non-seeing area, until it is detected by the patient. Typically, the target is brought toward the

center from several directions and the operator marks the location at which the patient first

detects the target (threshold point).

Kinetic test results can only be reliably related to specific parts of the visual field if points are

joined to form an isopter, or ring of equal contrast sensitivity. Targets of varying size and

brightness are used during one kinetic test, and for each different target, a different isopter is

mapped. When reviewing several isopters, the clinician is visualizing different tiers in the hill

of vision.

A second method of evaluating retinal function is known as static threshold testing. The term

“static” refers to a stationary (rather than moving) stimulus being used.

In static testing, predefined test locations in the visual field are probed. Through a series of

stimulus presentations of varying brightness intensities, the threshold value is determined for

each test point. When evaluating static test results, clinicians are looking at the topography or

contour of the hill of vision, and whether depressions are evident.

Patient fixation and

In order for any visual field test to be clinically useful, it must yield reliable results. One

test reliability

important factor affecting reliability is the steadiness of patient fixation. Unless the eye being

tested accurately fixates on the target while responding to stimuli, the results are unreliable.

Other factors adversely affecting reliability are:

• patient fatigue and anxiety

• poor test instructions

• patient discomfort

• improper near vision correction for central testing.

1.htp

3/14/03, 2:41 PM

4