Zeiss HUMPHREY 720i User Manual - page 197

CUSTOM TESTING

10-9

REV. B 02/03 PN 51680-1

HUMPHREY FIELD ANALYZER II - 

i 

series

4

The Custom screen now

displays each point in the

grid.

5

 To input an additional set of Grid points for the same test, repeat steps 1 through 4. There

can be a maximum of 248 points in a test.

When you have completed the entry of Custom points, you need to save the pattern for future

testing. See “Saving Custom Tests” later in this section.

Notes:

1.

 Each point in the last grid

you enter will appear as a

small square, not a point.

The previously entered Grid

will turn from squares to

points. This is to make the

most recently programmed

points more noticeable on

the Custom screen. This will

not affect the size of the

points projected during the

test.

2.

 If you add a grid that is either too close to a previously entered point or completely

outside of the selected field size, the instrument will reject your selection. Change the

point spacing either by pressing CHANGE OPTIONS and selecting a different spacing

option or by placing the grid in a different location.

3.

 If you create a Grid where some points fall outside the selected field size, only the

points within the field will be tested.

10.htp

3/14/03, 2:43 PM

9