Zeiss HUMPHREY 720i User Manual - page 42
GENERAL OPERATION
REV. B 02/03 PN 51680-1
HUMPHREY FIELD ANALYZER II -
i
series
2-16
Accessing the save/transmit
1
Start at the System Setup
option - network connection
screen. Select the Save /
Transmit option. Press
TRANSMIT VIA to display
“Network.” Press NETWORK
TRANSMIT SETTINGS.
2
Selecting any of the
network address buttons
will display the keypad. Specify
the instrument IP address, the
remote host IP address and
(destination) port number, the
default gateway and the subnet mask. Enter the addresses where appropriate, remembering to
include the dots if needed. If an entry is invalid, an alert will be displayed. Press PROCEED
when all the addresses have been entered.
3
Make sure the network
connections are secure
and the proper addressing has
been established at the other
networked unit. Press TEST
NETWORK CONNECTION to
verify a connection was made
at the destination instrument.
If successful, a message will
indicate “A connection was
successfully established with
the remote host.” If the
connection fails, the message
will read “Unable to establish connection with the remote host. Verify the instrument and host
network setup and try again.”
Selecting the printer type
1
Start at the System Setup
screen. Select the Printer
drop-down menu.
2
Choose between
HP LASERJET and
PRINTREX.
Note: Choose HP LASERJET if
using the optional GoPrint
device.
2.htp
3/14/03, 1:51 PM
16