Zeiss HUMPHREY 720i User Manual - page 25
Manual is about: FIELD ANALYZER II - i series
of
328
INTRODUCTION / INSTRUMENT SETUP
1-17
REV. B 02/03 PN 51680-1
HUMPHREY FIELD ANALYZER II -
i
series
1
Open rear panel on back of HFA II.
Connect printer cable to Printrex
printer and HFA II at rear of unit (see
close-up Figure 1.8).
2
Attach Printrex power cord to
special outlet on underside of
table.
3
Connect power cord from back
of HFA II to power outlet on
underside of table.
4
Attach keyboard and glidepad or
trackball / mouse if desired.
Replace rear panel, being careful to
run cables out through slot at bottom
(see Figure 1.5)
5
Attach power cord at base of table
and connect to wall outlet.
6
Turn on power to the
Printrex printer.
7
Turn on power to the HFA II.
Figure 1.9: The HFA II – Rear View on Instrument Table
1
1
2
3
5
4
7
6
SYSTEM
ASSEMBLY
1.htp
3/14/03, 2:42 PM
17