Can-Am 2009 Renegade 500 Operator's Manual - Battery
MAINTENANCE PROCEDURES
Torque
spark
plugs
to
20
N•m
(15 lbf•ft).
Battery
WARNING
Unless otherwise indicated, al-
ways turn ignition switch to the
OFF position before performing
any maintenance or repair on elec-
trical system.
WARNING
Never charge a battery while in-
stalled in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
NOTICE
Never remove the battery
sealing cap.
Battery Removal
Remove storage box.
Disconnect BLACK (-) cable first then
RED (+) cable.
WARNING
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first.
Unfasten retaining rod.
vmr2007-047-001_a
Pull out top bracket.
Remove battery.
Battery Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery casing should
be cleaned by soft brush and baking
soda solution.
Battery Installation
Reinstall battery in vehicle.
WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.
Fuses
WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective fuse.
The electrical system is protected with
fuses.
102
______________