Can-Am 2009 Renegade 500 Operator's Manual - page 69
CONTROLS/INSTRUMENTS/EQUIPMENTS
RPM Mode
In this mode, the display shows the en-
gine RPM.
vdd2008-001-089
Combined Mode
In this mode, the display shows the
speed of the vehicle and the engine
RPM.
vdd2008-001-085_a
1. Vehicle speed
2. Engine RPM
Mode Change
To change from one display to the oth-
er, proceed as follows.
1. Turn ignition key to ON to power the
system up.
2. Wait until “greeting message” is
finished.
3. Press and release selector button
once to display OD (odometer).
4. Press the selector button again,
this time for 2 seconds.
This will change the Mode to either
Speed, RPM or Combined.
vdd2008-001-083
5. To select another mode, repeat
steps 3 and 4 until you get the
mode desired.
Multifunction Display
(temporary display mode)
Press and release selector button to
change the normal display mode to the
following temporary mode:
– Odometer
– Trip meter (resettable)
– Hour meter (resettable)
– Vehicle hour meter.
vmr2007-050-002_c
1. Selector button
The gauge will display the selected
mode for 10 seconds then will return
to the normal display mode.
While in a resettable mode, push and
HOLD selector button for 2 seconds to
reset it.
Odometer (ODO)
Odometer records the total distance
travelled either in miles or kilometers.
_______________
67