Can-Am 2009 Renegade 500 Operator's Manual - Engine Oil
MAINTENANCE PROCEDURES
Remove foam prefilter by carefully
pushing the extremities toward the in-
side.
vmo2009-008-041_a
1. Foam prefilter extremities
vmo2009-008-042_a
1. Foam prefilter
2. Filter
Air Filter Cleaning
Foam Prefilter Cleaning
Pour cleaning solution (P/N 219 700
341) or an equivalent into a bucket.
Put the foam prefilter in to soak.
While foam prefilter soaks, clean in-
side the air filter housing.
Rinse the foam prefilter with warm
water until all cleaning solution disap-
pears.
Let the foam prefilter dry completely.
Filter Cleaning
Blow low pressure compressed air on
filter element to clean it.
NOTICE
Do not wash the paper fil-
ter with any cleaning solution.
Air Filter Installation
Properly reinstall removed parts in the
reverse order of their removal.
Engine Oil
Engine Oil Level
NOTICE
Check
level
frequently
and refill if necessary. Do not over-
fill. Operating the engine with an
improper level may severely dam-
age engine. Wipe off any spillage.
NOTE: While checking the oil level, vi-
sually inspect engine area for leaks.
vmo2008-005-001_c
RH SIDE OF ENGINE
1. Dipstick
With vehicle on a level surface and en-
gine cold, not running, check the oil lev-
el as follows:
1. Unscrew dipstick then remove it
and wipe clean.
2. Reinstall dipstick, screw in it com-
pletely.
3. Remove and check oil level. It
should be near or equal to the up-
per mark.
90
______________