Can-Am 2009 Renegade 500 Operator's Manual - 9) 12-Volt Power Outlet
CONTROLS/INSTRUMENTS/EQUIPMENTS
Indicator Lamps
vmr2007-050-002_k
1. 4WD indicator lamp
2. Low fuel level indicator lamp
3. Check engine indicator lamp
4. High beam indicator lamp
5. MPH or km/h indicator lamp
When this indicator is ON, it in-
dicates the 4WD system is acti-
vated.
When this indicator is ON, it in-
dicates that there is only 30%
of fuel left in fuel tank, approxi-
mately 6 L (1.6 U.S. gal).
When this indicator is ON, it in-
dicates an engine fault code,
look for a message at the multi-
function display.
When this indicator blinks, it in-
dicates that the LIMP HOME
mode is activated,
refer to
TROUBLESHOOTING
for more
details.
When this indicator is ON, it
indicates that high intensity is
selected on the headlights and
that ignition key is in LIGHTS po-
sition.
The proper lamp turns on to in-
dicate the unit the speedometer
uses.
Multifunction Display Messages
Refer to
TROUBLESHOOTING
section
for details.
9) 12-Volt Power Outlet
Convenient for handheld spotlight or
other portable equipment.
Remove protective cap to use. Always
reinstall it after use to protect against
weather.
Do not exceed the rating capacity. See
SPECIFICATIONS
.
An auxiliary supply is available to con-
nect additional accessories. Two wires
are hidden in the wiring harness at
the front of vehicle underneath dash
board. See an authorized Can-Am deal-
er for more details.
10) Ignition Switch
Key-operated 3-position switch.
vmo2007-015-008_a
IGNITION SWITCH POSITIONS
1. OFF
2. ON “with light”
3. ON “without light”
Insert key in switch and turn to the de-
sired position. To remove key, turn key
to OFF position then pull it out.
_______________
69