Can-Am 2009 Renegade 500 Operator's Manual - page 128
MESSAGES IN MULTIFUNCTION GAUGE
MESSAGE
DESCRIPTION
INVALID KEY
Indicates that you have used the wrong ignition key, use the prop-
er key for this vehicle.
It is also possible that the ignition key has a bad contact, remove
and clean key.
BRAKE
Is displayed when parking brake is applied for more than 15 sec-
onds.
LO BATT
Low battery voltage, check battery voltage and charging system.
HI BATT
High battery voltage, check battery voltage and charging system.
LOW OIL
(1)
Engine low oil pressure, stop engine immediately and check oil
level.
LOW FUEL
LOW FUEL indicator lamp also turns on. Refer to
INDICATOR
LAMPS
.
HI TEMP
(2)
Engine is overheating, refer to
ENGINE OVERHEAT
in
TROU-
BLESHOOTING
.
LIMP HOME
Serious fault on the engine that can change the normal operation
of the engine, CHECK ENGINE indicator lamp will also blink, refer
to
TROUBLESHOOTING
for more details.
CHECK ENGINE
Engine fault, CHECK ENGINE indicator lamp will also be ON, see
an authorized Can-Am dealer.
MAINTENANCE
SOON
(3)
Periodic maintenance required. See an authorized Can-Am dealer.
NO ECM
COMMUNICATION
Communication error between gauge and engine control module
(ECM), contact an authorized Can-Am dealer.
NOTICE
(1)
If the light does not cut out right after engine starting, stop
engine. Check engine oil level. Refill if necessary. If the oil level is good, see
an authorized Can-Am dealer. Do not use the vehicle until repaired.
NOTICE
(2)
If the light does not turn off right after engine starting, stop en-
gine. See an authorized Can-Am dealer. Do not use the vehicle until repaired.
(3)
Message must be erased by an authorized Can-Am dealer.
126
______________