Can-Am 2009 Renegade 500 Operator's Manual - Radiator
MAINTENANCE PROCEDURES
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the oil drain plug area.
Place a drain pan under the oil drain
plug area.
Unscrew oil drain plug.
vmo2006-007-019_a
TYPICAL
1. Oil drain plug
2. Brake pedal
Allow enough time for oil to flow out of
oil filter.
Remove the right side panel.
Unscrew the oil filter cover.
vmo2006-007-020_a
1. Oil filter cover
Remove the oil filter and replace with a
new filter.
Check the cover O-ring and change it if
necessary.
Screw oil filter cover in place.
Wipe off any oil spillage on engine.
Change gasket on oil drain plug. Clean
gasket area on engine and oil drain plug
then reinstall plug. Refill engine at the
proper level with the recommended
oil. Refer to
SPECIFICATIONS
for ca-
pacity.
Start engine and let idle for a few min-
utes. Ensure oil filter area and oil drain
plug areas are not leaking.
Stop engine. Wait a while to allow oil to
flow down to crankcase then check oil
level. Refill as necessary.
Dispose of oil as per your local environ-
mental regulations.
Radiator
Radiator Inspection
Periodically check the radiator area for
cleanliness.
vmo2007-015-012_a
1. Radiator
Inspect radiator and hoses for leaks or
any damage.
92
______________