Can-Am 2009 Renegade 500 Operator's Manual - Warning
CONTROLS/INSTRUMENTS/EQUIPMENTS
Engine Stop Switch
This switch can be used to stop the en-
gine and as an emergency control.
To stop engine, fully release throttle
lever then use the engine stop switch.
NOTE: While engine can be stopped
by turning ignition key to OFF position,
we recommend the engine be stopped
by the engine stop switch.
V07I05Y
1
TYPICAL
1. Engine stop switch
Engine Start Button
To start engine, place the engine stop
switch to RUN.
Press and hold the engine start button.
Release immediately after engine is
started.
V07I06Y
2
1
TYPICAL
1. Engine start button
2. Engine stop switch
NOTE: The engine will not turn over if
the engine stop switch and/or ignition
switch are turned to the OFF position.
Override Button
This button is used to override the re-
verse speed limiter system while pow-
er backing up. Press and hold the over-
ride button then depress throttle lever
gradually.
WARNING
Never activate the override but-
ton if throttle lever is already de-
pressed as a loss of control may
result, causing severe personal in-
jury or death.
While reading this Operator’s Guide, reminder that:
WARNING
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
_______________
65