Can-Am 2009 Renegade 500 Operator's Manual - page 70
CONTROLS/INSTRUMENTS/EQUIPMENTS
Trip Meter (trip)
The trip meter records the travelled dis-
tance since it has been reset. Distance
travelled is displayed either in miles or
kilometers.
It can be used to establish a fuel tank
range or distance between 2 way
points for instance.
Push and HOLD display selection but-
ton for 2 seconds to reset the trip me-
ter.
Hour Meter (trip time)
The hour meter records vehicle run-
ning time when the electrical system
is activated. It can be used to establish
traveling time between 2 way points
for instance.
Push and HOLD display selection but-
ton for 2 seconds to reset the hour me-
ter.
Hour Meter (engine hours)
The hour meter records engine running
time.
Transmission Position Display
This display will show transmission po-
sition.
vmr2007-050-002_d
1. Transmission position
DISPLAY
FUNCTION
P
Park
R
Reverse
N
Neutral
H
High Gear
L
Low Gear
NOTE: If the letter “E” is displayed
in the transmission position display, it
means that there is a electrical commu-
nication error. Contact an authorized
Can-Am dealer.
Fuel Level Display
Bar gauge continuously indicates the
amount of fuel in the fuel tank while
riding.
When the low fuel indicator lamp is
ON, it indicates that there is only 30%
of fuel left in fuel tank, approximately
6 L (1.6 U.S. gal).
vmr2007-050-002_e
1. Fuel level display
2. Low fuel indicator lamp
68
______________