Can-Am 2009 Renegade 500 Operator's Manual - Warning
MAINTENANCE PROCEDURES
TIRE PRESSURE
FRONT
REAR
MAX.
48 kPa
(7 PSI)
48 kPa
(7 PSI)
UP to
141 kg
(310 lb)
MIN.
34.5 kPa
(5 PSI)
38 kPa
(5.5 PSI)
NOTE: Although the tires are specif-
ically designed for off-road use, a flat
may still occur. Therefore, it is rec-
ommended to carry a tire pump and a
repair kit.
Tire Inspection
Check tire for damage and wear. Re-
place if necessary.
Do not rotate tires. The front and rear
tires have a different size. The tires are
directional and their rotation must be
kept in a specific direction for proper
operation.
Tire Replacement
WARNING
When the tires are replaced, nev-
er install a bias tire with a radial
tire. Such a combination could
create handling and/or stability
problems.
Do not mix tires of different size
and/or design on the same axle.
Front and rear tire pairs must have
an identical model and manufac-
turer.
For unidirectional tread pattern,
ensure that the tires are installed
in the correct direction of rotation.
The radial tires must be installed
as a complete set.
Severe injury or death can result
if you do not follow these instruc-
tions.
Suspension
Suspension Lubrication
Lubricate front A-arms. Use suspen-
sion synthetic grease (P/N 293 550
033) or an equivalent. There is two
grease fittings on each A-arm.
Front Suspension Inspection
Inspect shock absorber for leaks or
other damages. Check tightness of
fasteners. See an authorized Can-Am
dealer as necessary.
A-Arms
Check A-arms for cracks, bending or
other damages. See an authorized
Can-Am dealer as necessary.
Rear Suspension Inspection
Inspect shock absorber for leaks or
other damages. Check tightness of
fasteners. See an authorized Can-Am
dealer as necessary.
Trailing Arms
Check trailing arms for distortion,
cracks or bending. See an authorized
Can-Am dealer if any problem is de-
tected.
Brake
Brake Fluid Level
With vehicle on a level surface, check
brake fluid in reservoirs for proper lev-
el. They should be above MIN. mark.
Add fluid as required. Do not overfill.
Clean filler cap before removing.
NOTICE
Use only DOT 4 brake flu-
id from a sealed container. Do not
use brake fluid taken from old or al-
ready opened containers.
______________
107