Can-Am 2009 Renegade 500 Operator's Manual - Warning
MAINTENANCE PROCEDURES
NOTE: A low level may indicate leaks
or worn brake pads. See an authorized
Can-Am dealer.
Front and Rear Brake Lever Fluid
Reservoir
V07K0AA
TYPICAL
Turn steering in the straight-ahead po-
sition to ensure reservoir is level.
Check the brake fluid level, the reser-
voir is full when the fluid reaches of the
top of window.
Visually inspect lever boot condition.
Check for cracks, tears, etc. Replace if
damaged.
Repeat the same procedure for the
other reservoir.
Rear Brake Pedal Fluid Reservoir
With vehicle on a level surface, brake
fluid should be between MIN. and
MAX. level marks.
vmo2008-014-002_b
Recommended Brake Fluid
Always use brake fluid meeting the
specification DOT 4 only.
NOTICE
To avoid serious damage
to the braking system, do not use
fluids other than the recommended
one, nor mix different fluids for top-
ping up.
Brake Inspection
The braking system is an hydraulic type
and no adjustment is required.
Check the following to keep the brakes
in a good operating condition:
– Brake fluid level
– Brake system for fluid leaks
– Brake for spongy feel
– Brake cleanliness
– Brake discs for excessive wear and
surface condition
– Brake pads for wear, damage or
looseness.
SERVICE LIMITS
Brake pads
thickness
1 mm (.040 in)
Front discs
thickness
3.5 mm (.138 in)
Rear disc
thickness
4.3 mm (.170 in)
Maximum discs
warpage
0.3 mm (.010 in)
See your authorized Can-Am dealer if
a problem is detected concerning the
brake system.
WARNING
The brake fluid replacement or
brake system maintenance and
repairs should be performed by an
authorized Can-Am dealer.
108
______________