Can-Am 2009 Renegade 500 Operator's Manual - 8) Multifunction Gauge
CONTROLS/INSTRUMENTS/EQUIPMENTS
1
V07I07Y
2
TYPICAL
1. Override button
2. Engine stop switch
8) Multifunction Gauge
WARNING
Never adjust or set functions on
the multifunction gauge while rid-
ing the vehicle.
This vehicle is equipped with an elec-
tronic multifunction gauge.
The functions on this gauge are:
vmr2007-050-002_h
1. Multifunction display selector button
2. Transmission position display
3. Multifunction display
4. Fuel level display
5. 4WD indicator lamp
6. Low fuel level indicator lamp
7. Check engine indicator lamp
8. High beam indicator lamp
9. MPH, Km/h indicator lamp
Unit Selection (MPH vs km/h)
The speedometer, odometer and trip
meter are factory preset in miles but
it is possible to change them to kilo-
meter reading. Contact an authorized
Can-Am dealer.
Multifunction Display
(normal display mode)
After vehicle startup, the normal dis-
play mode shows either:
– Vehicle speed
– Engine revolution per minute (RPM)
– Both parameters simultaneously
(combined mode).
Speed Mode
In this mode, the display shows the
speed of the vehicle either in km/h or
in MPH.
vdd2008-001-084
66
______________