Can-Am 2009 Renegade 500 Operator's Manual - page 105
MAINTENANCE PROCEDURES
If a fuse is damaged, replace it by one
of the same rating.
NOTICE
Do not use a higher rated
fuse as this can cause severe dam-
age.
Fuse Inspection
To remove fuse from holder, remove
the fuse holder cover then pull fuse
out. Check if filament is melted.
A15E0KY
1
2
TYPICAL
1. Fuse
2. Check if melted
Front Fuses Location
fuses holder is located in the front ser-
vice compartment Refer to
BODY
.
vmo2006-007-012_a
TYPICAL — FRONT FUSES LOCATION
1. (F1) Ignition coils (5 A)
2. (F2) Fan (20 A)
3. (F3) Fuel injectors (5 A)
4. (F4) Speedometer/speed sensor/taillight
(7.5 A)
5. (F5) Fuel pump (7.5 A)
6. (F6) Engine Control Module (ECM) (5 A)
7. (F7) Accessories (20 A)
Rear Fuses Location
fuse are located at the back near bat-
tery behind thread cover.
vmo2006-007-031_a
TYPICAL — REAR FUSES LOCATION
1. (F8) Main (30 A)
(F9) Main accessories (30 A)
______________
103