D-Link DES-2110 User manual - Igmp Snooping Commands
102
IGMP Snooping Commands
The IGMP Snooping commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following
table.
Command
Parameters
config router_ports
[add | delete]
enable igmp snooping
disable igmp snooping
show router ports
show igmp_snooping
group
config igmp_snooping
[host_timeout
router_timeout
Each command is listed, in detail, in the following sections.
config router_ports
Purpose
Used to configure ports as router ports.
Syntax config
router_ports
[add | delete]
Description
This command allows you to designate a range
of ports as being connected to multicast-enabled
routers. This will ensure that all packets with
such a router as its destination will reach the
multicast-enabled router − regardless of protocol,
etc.
Parameters
add / delete - Add or delete the specifies a port
or range of ports that will be configure as router
ports.
will be configured as router ports.