D-Link DES-2110 User manual - Enable Igmp Snooping
Manual is about: 8-port 10/100 + 1-port 1000Base-T Copper
+ 1-port miniGBIC Gigabit Switch
of
126
Example usage:
To set up static router ports:
Figure 95. config router_ports command (add static router ports)
To delete static router ports:
Figure 96. config router_ports command (delete static router ports)
enable igmp snooping
Purpose
Used to enable IGMP snooping on the Switch.
Syntax
enable igmp snooping {forward_mcrouter_only}
Description
This command allows you to enable IGMP snooping
on the Switch. If forward_mcrouter_only is specified,
the Switch will only forward all multicast traffic to the
multicast router, only. Otherwise, the Switch
forwards all multicast traffic to any IP router.
Parameters
None.
103