D-Link DES-2110 User manual - Config Stp
90
config stp
Parameters
devices on the bridged LAN. If the value ages out
and a BPDU has still not been received from the
Root Bridge, the Switch will sending its own
BPDU to all other switches for permission
become the Root Bridge. If it turns on that your
switch has the lowest Bridge identifier, it will
become the Root Bridge. The user may choose a
time between 6 and 40 seconds. The default
value is 20.
hellotime
time interval between transmission of
configuration messages by the root device, thus
stating that the Switch is still functioning. A time
between 1 and 10 seconds may be chosen, with
a default setting of 2 seconds.
forwarddelay
amount of time (in seconds) that the root device
will wait before changing states. The user may
choose a time between 4 and 30 seconds. The
default is 15 seconds.
priority
between 1 and 65535 to specify the priority for
forwarding packets. The lower the value, the
higher the priority. The default is 32768.
fbpdu [enable | disable] - Allows the forwarding
of STP BPDU packets from other network
devices when STP is disabled on the Switch. The
default is enable.