D-Link DES-2110 User manual - Save
Manual is about: 8-port 10/100 + 1-port 1000Base-T Copper
+ 1-port miniGBIC Gigabit Switch
of
126
65
save
Purpose
Used to save changes in the Switch’s
configuration to non-volatile RAM.
Syntax save
Description
This command is used to enter the current switch
configuration into non-volatile RAM. The saved
switch configuration will be loaded into the
Switch’s memory each time the Switch is
restarted.
Parameters
None.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
Figure 57. save command
Basic IP Commands
The basic IP commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
Parameters
config ipif
[ipaddress
show ipif