D-Link DES-2110 User manual - Config Ipif
Each command is listed, in detail, in the following sections.
config ipif
Purpose
Used to configure the System IP interface.
Syntax
config ipif [ipaddress
{gw
Description
This command is used to configure the System
IP interface on the Switch.
Parameters
ipaddress
netmask of the IP interface to created. You can
specify the address and mask information using
traditional format (for example,
Parameters
192.168.100.100/255.255.255.0 of in CIDR
format, 192.168.100.100/24.
dhcp - Allows the selection of the DHCP protocol
for the assignment of an IP address to Switch’s
system IP address.
Switch. The range between 1 to 4094.
Example usage:
To configure the IP interface System:
Figure 58. config ipif command
66