D-Link DES-2110 User manual - Vlan Commands
Manual is about: 8-port 10/100 + 1-port 1000Base-T Copper
+ 1-port miniGBIC Gigabit Switch
of
126
71
VLAN Commands
The VLAN commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
Parameters
create vlan
[ 1~4094>] delete vlan 1~4094>} config vlan [ 1~4094>} [add {[tagged | untagged]}| delete]
show vlan {[ 1~4094>]} enable port_based vlan disable port_based vlan enable 802.1q_based vlan disable 802.1q_based vlan config pvid <0-7> Each command is listed, in detail, in the following sections. Purpose Used to create a VLAN on the Switch. Syntax create vlan [ 1~4094>] Description This command allows you to create a VLAN on the Switch. Command
Parameters
create vlan