D-Link DES-2110 User manual - Config Stp Ports
Example usage:
To configure STP with maxage 40 and hellotime of 5 seconds:
Figure 84. config stp command
config stp ports
Purpose
Used to setup STP on the port level.
Syntax
config stp ports [all |
1-65535> | priority
Description
This command is used to create and configure
STP for a group of ports.
Parameters
[all |
ports to be configured.
cost
that indicates the relative cost of forwarding
packets to specified port list. The value between
1 and 65535 to determine the cost. The lower the
number, the greater the probability the port will
be chosen to forward packets. The default value
is 10.
priority
0 and 255 to specify the priority for a specified
port for forwarding packets. The lower the value,
the higher the priority. The default is 128.
91