D-Link DES-2110 User manual - Command
Manual is about: 8-port 10/100 + 1-port 1000Base-T Copper
+ 1-port miniGBIC Gigabit Switch
of
126
88
Command
Parameters
enable stp
disable stp
config stp
{maxage
| priority
[enable | disable]}
config stp ports
[all | 65535> | priority show stp show stp ports
Each command is listed, in detail, in the following sections. Purpose Used to enable STP on the Switch. Syntax enable stp Description This command allows the Spanning Tree Protocol to be enabled on the Switch. Parameters None. Example usage: To enable STP on the Switch: Figure 82. enable stp command enable stp