D-Link DES-2110 User manual - Telnet Ip-Address
Manual is about: 8-port 10/100 + 1-port 1000Base-T Copper
+ 1-port miniGBIC Gigabit Switch
of
126
Using the CLI via Telnet interface
To configure the Switch through the TCP/IP Telnet protocol, using an
ordinary telnet client program. On many systems to invoke a telnet
client is:
telnet ip-address
Where ip-address is the IP address you have assigned to the Switch.
When you telnet to the Switch, it displays its login-in message:
Figure 49. The DES-2110 console login
At this point you can enter the password you have assigned to your
print server. The factory default password is “admin”.
The Switch will then display the telnet interface CLI command
prompt:
57