D-Link xStack DGS-3426 User Manual - page 103
xStack DGS-3400 Series Fast Ethernet Switch
Figure 7- 11. Link Aggregation Settings window - Modify
The user-changeable parameters are as follows:
Parameter
Description
Group ID
Select an ID number for the group, between 1 and 32.
State
Trunk groups can be toggled between Enabled and Disabled. This is used to
turn a port trunking group on or off. This is useful for diagnostics, to quickly
isolate a bandwidth intensive network device or to have an absolute backup
aggregation group that is not under automatic control.
Master Port
Choose the Master Port for the trunk group using the pull-down menu.
Member Ports
Choose the members of a trunked group. Up to eight ports per group can be
assigned to a group.
Flooding Port
A trunking group must designate one port to allow transmission of broadcasts
and unknown unicasts.
Active Port
Shows the port that is currently forwarding packets.
Type
This pull-down menu allows you to select between Static and LACP (Link
Aggregation Control Protocol). LACP allows for the automatic detection of
links in a Port Trunking Group.
After setting the previous parameters, click Apply to allow your changes to be implemented. Successfully created trunk
groups will be show in the Current Link Aggregation Group Entries.
92