D-Link xStack DGS-3426 User Manual - page 134
xStack DGS-3400 Series Fast Ethernet Switch
The page shown below is the IPv6 configuration window.
Figure 7- 43. Access Profile Configuration window (IPv6)
The following parameters can be set, for IP:
Parameter
Description
Profile ID (1-6)
Type in a unique identifier number for this profile set. This value can be set
from 1 - 6.
Type
Select profile based on Ethernet (MAC Address), IP or IPv6 address. This will
change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each
packet header.
Select IP to instruct the Switch to examine the IP address in each frame's
header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's
header.
Class
Checking this field will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the Type
of Service (ToS) or Precedence bits field in IPv4.
Flowlabel
Checking this field will instruct the Switch to examine the flow label field of the
IPv6 header. This flow label field is used by a source to label sequences of
packets such as non-default quality of service or real time service packets.
Source IPv6 Mask
The user may specify an IP address mask for the source IPv6 address by
checking the corresponding box and entering the IP address mask.
Destination IPv6 Mask
The user may specify an IP address mask for the destination IPv6 address by
checking the corresponding box and entering the IP address mask.
Click Apply to implement changes made.
123