D-Link xStack DGS-3426 User Manual - Section 9
xStack DGS-3400 Series Fast Ethernet Switch
Section 9
Save, Reset and Reboot
Saving Changes
Reboot System
Reset Configuration
Save Changes
The Switch has two levels of memory, normal RAM and non-volatile or NV-RAM. Configuration changes are made
effective clicking the Save button. When this is done, the settings will be immediately applied to the switching software in
RAM, and will immediately take effect.
Some settings, though, require you to restart the Switch before they will take effect. Restarting the Switch erases all
settings in RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-
RAM before rebooting the switch.
To retain any configuration changes permanently, click on the Save button in the Save Changes menu. The save optionas
allow one alternative configuration image to be stored.
Figure 9- 1. Save Changes menu
The Save Changes options include:
Save Configuration_ID_1 to save the configuration file indexed as Image file 1. To use this file for configuration it
must be designated as the Boot configuration using the Config Currnet Setting menu (Save Services > Config
Current Setting)
•
•
•
•
Save Configuration_ID_2 to save the configuration file indexed as Image file 2. To use this file for configuration it
must be designated as the Boot configuration using the Config Currnet Setting menu (Save Services > Config
Current Setting)
Save Log to save only the current log.
Save All to save the current configuration file indexed as Image file 1 and save the current log.
169