D-Link xStack DGS-3426 User Manual - page 139
xStack DGS-3400 Series Fast Ethernet Switch
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameter
Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are
forwarded by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 -
128.
Type
Selected profile based on Ethernet (MAC Address), IP address or IPv6 address
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
IPv6 instructs the Switch to examine the IPv6 address in each frame's header.
Priority (0-7)
This parameter is specified if you want to re-write the 802.1p default priority
previously set in the Switch, which is used to determine the CoS queue to which
packets are forwarded to. Once this field is specified, packets accepted by the
Switch that match this priority are forwarded to the CoS queue specified previously
by the user.
replace priority
− Click the corresponding box if you want to re-write the 802.1p
default priority of a packet to the value entered in the Priority field, which meets the
criteria specified previously in this command, before forwarding it on to the
specified CoS queue. Otherwise, a packet will have its incoming 802.1p user
priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see
the QoS section of this manual.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source MAC
Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC
Destination MAC Address - Enter a MAC Address mask for the destination MAC
address.
802.1p (0-7)
Enter a value from 0-7 to specify that the access profile will apply only to packets
with this 802.1p priority value.
Ethernet Type
Specifies that the access profile will apply only to packets with this hexadecimal
802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet
type value may be set in the form: hex 0x0-0xffff, which means the user may
choose any combination of letters and numbers ranging from a-f and from 0-9999.
Port
The Access Rule may be configured on a per-port basis by entering the port
number of the switch.
Rx rate
A limit may be set on the incoming rate for the access rule.
128