D-Link xStack DGS-3426 User Manual - page 67
xStack DGS-3400 Series Fast Ethernet Switch
To enter an IPv6 Interface into the IPv6 Static Route list, click the Add button, revealing the following window to
configure.
Figure 6- 30. Static/Default Route Settings – Add menu
Click to select the default option if this will be the default IPv6 route. Choosing this option will allow the user to configure
the default gateway for the next hop router only.
The following fields can be set:
Parameter
Description
IPv6 Address/Netmask
Specify the address and mask information using the format as ipv6address / prefix
length (ipv6address is hexadecimal number, prefix length is decimal number, for
example 1234::5D7F/32).
Next Hop Address
Enter the IPv6 address for the next hop Gateway address in IPv6 format.
Metric (1-65535)
The metric representing the number of routers between the Switch and the IPv6
address above.
default
Select the default option to define the entry as a 1 hop IPv6 default route.
Click Apply to implement changes made.
DHCP Auto Configuration Settings
This window is used to enable the DHCP Autoconfiguration feature on the Switch. When enabled, the Switch is instructed
to receive a configuration file from a TFTP server, which will set the Switch to become a DHCP client automatically on
boot up. To employ this method, the DHCP server must be set up to deliver the TFTP server Ip address and configuration
file name information in the DHCP reply packet. The TFTP server must be up and running and hold the necessary
configuration file stored in its base directory when the request is received from the Switch. For more information about
loading a configuration file for use by a client, see the DHCP server and/or TFTP server software instructions. The user
may also cunsult the Upload screen description located in the Maintenance section of this manual.
If the Switch is unable to complete the DHCP auto configuration, the previously saved configuration file present in the
Switch’s memory will be used.
Figure 6- 31. DHCP Auto Configuration Settings window
To enable the DHCP Auto Configuration State, use the pull-down menu to choose Enable and click the Apply button.
56