D-Link xStack DGS-3426 User Manual - Bandwidth Control
xStack DGS-3400 Series Fast Ethernet Switch
Bandwidth Control
The bandwidth control settings are used to place a ceiling on the transmitting and receiving data rates for any selected port.
In the QoS folder, click Bandwidth Control, to view the screen shown below.
Figure 7- 34. Bandwidth Settings and Port Bandwidth Table window
The following parameters can be set or are displayed:
Parameter
Description
From/To
A consecutive group of ports may be configured starting with the selected port.
Type
This drop-down menu allows a selection between RX (receive,) TX (transmit,)
and Both. This setting will determine whether the bandwidth ceiling is applied
to receiving, transmitting, or both receiving and transmitting packets.
No Limit
This drop-down menu allows the user to specify that the selected port will have
no bandwidth limit. Enabled disables the limit.
Rate
This field allows the input of the data rate, in Mbit/s, that will be the limit for the
selected port. The user may choose a rate between 1 and 9999 Mbit/s.
Click Apply to set the bandwidth control for the selected ports. Results of configured Bandwidth Settings will be
displayed in the Port Bandwidth Table.
114