D-Link xStack DGS-3426 User Manual - page 148
xStack DGS-3400 Series Fast Ethernet Switch
Figure 7- 60. CPU Interface Filtering Rule Configuration – Ethernet
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameter
Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are
forwarded by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access and priority. This value can be
set from 1 - 100.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source MAC
Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC
Destination MAC Address - Enter a MAC Address mask for the destination MAC
address.
802.1p (0-7)
Specify the rule be based on 802.1p priority.
Ethernet Type
Specifies that the access profile will apply only to packets with this hexadecimal
802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet
type value may be set in the form: hex 0x0-0xffff, which means the user may
choose any combination of letters and numbers ranging from a-f and from 0-9999.
Port
The rule may be configured on a per-port basis by entering the port number of the
switch.
137