D-Link xStack DGS-3426 User Manual - Multiple Image Services
xStack DGS-3400 Series Fast Ethernet Switch
Multiple Image Services
The Multiple Image Services folder allows users of the Switch to configure and view information regarding firmware
located on the Switch. The Switch allows two firmware images to be stored in its memory and either can be configured to
be the boot up firmware for the Switch. For information regarding firmware images located on the Switch, open the
Firmware Information link. The default setting for the Switch’s firmware will have the boot up firmware stored in Image
1, but the user may set either firmware stored to be the boot up firmware by using the Config Firmware Image menu.
Firmware Information
The following screen allows the user to view information about current firmware images stored on the Switch. To access
the following screen, click Administration > Multiple Image Services.
Figure 6- 17. Firmware Information window
This window holds the following information:
Parameter
Description
ID
States the image ID number of the firmware in the Switch’s memory. The
Switch can store 2 firmware images for use. Image ID 1 will be the default boot
up firmware for the Switch unless otherwise configured by the user.
Version
States the firmware version.
Size
States the size of the corresponding firmware, in bytes.
Update Time
States the specific time the firmware version was downloaded to the Switch.
From
States the IP address of the origin of the firmware. There are five ways
firmware may be downloaded to the Switch.
R – If the IP address has this letter attached to it, it denotes a firmware
upgrade through the Console Serial Port (RS-232).
T - If the IP address has this letter attached to it, it denotes a firmware upgrade
through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware upgrade
through the Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware
upgrade through the web-based management interface.
SIM – If the IP address has this letter attached to it, it denotes a firmware
upgrade through the Single IP Management feature.
User
States the user who downloaded the firmware. This field may read
“Anonymous” or “Unknown” for users that are not identified.
47