D-Link xStack DGS-3426 User Manual - page 150
xStack DGS-3400 Series Fast Ethernet Switch
Configure the following Access Rule Configuration settings for IP:
Parameter
Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are
forwarded by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 -
100.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source IP
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP
Destination IP Address- Enter an IP Address mask for the destination IP address.
Port
The rule may be configured on a per-port basis by entering the port number of the
switch.
To view the settings of a previously correctly configured rule, click
in the Access Rule Table to view the following
screen:
Figure 7- 64. CPU Interface Filtering Rule Display - IP
139