D-Link xStack DGS-3600 Series User Manual - Stp Port Settings
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Parameter Description
MSTI ID
Displays the MSTI ID of the instance being modified. An entry of 0 in this field denotes the
CIST (default MSTI).
Type
The Type field in this window will be permanently set to
Set Priority Only
.
Priority (0-61440)
Enter the new priority in the Priority
field. The user may set a priority value between 0-
61440.
Click
Apply
to implement the new priority setting.
STP Port Settings
STP can be set up on a port per port basis. To
view the STP Port Settings window click
L2
Features > Spanning Tree > STP Port
Settings
.
In addition to setting Spanning Tree parameters
for use on the switch level, the Switch allows for
the configuration of groups of ports, each port-
group of which will have its own spanning tree,
and will require some of its own configuration
settings. An STP Group will use the switch-level
parameters entered above, with the addition of
Port Priority and Port Cost. An STP Group
spanning tree works in the same way as the
switch-level spanning tree, but the root bridge
concept is replaced with a root port concept. A
root port is a port of the group that is elected
based on port priority and port cost, to be the
connection to the network for the group.
Redundant links will be blocked, just as
redundant links are blocked on the switch level.
The STP on the switch level blocks redundant
links between switches (and similar network
devices). The port level STP will block redundant
links within an STP Group.
It is advisable to define an STP Group to
correspond to a VLAN group of ports.
Figure 7- 36. STP Port Settings window
105