D-Link xStack DGS-3600 Series User Manual - Ipv6 Static Route Settings
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Parameter Description
IP Address
Allows the entry of an IP address that will be a static entry into the Switch’s Routing Table.
Subnet Mask
Allows the entry of a subnet mask corresponding to the IP address above.
Gateway
Allows the entry of an IP address of a gateway for the IP address above.
Metric (1-65535)
Allows the entry of a routing protocol metric representing the number of routers between the
Switch and the IP address above.
Backup State
The user may choose between
Primary
and
Backup.
If the Primary Static/Default Route fails,
the Backup Route will support the entry. Please take note that the Primary and Backup entries
cannot have the same Gateway.
Click
Apply
to implement changes made.
IPv6 Static Route Settings
A static entry of an IPv6 address can be entered into the Switch’s routing table for IPv6 formatted addresses. To view the
following window, click
Layer 3 > Routing Table > IPv6 Static Route Settings
.
Figure 8- 19. IPv6 Static Route Settings window
This window shows the following values:
Parameter Description
IPv6 Address/Netmask
The IPv6 address and corresponding Subnet Mask of the IPv6 static route entry.
Gateway
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
Metric (1-65535)
The metric of the IPv6 interface entered into the table representing the number of routers
between the Switch and the IPv6 address above. Metric values allowed are between 1-
65535.
Protocol
Represents the status (default or static) for the IPv6 routing table entry.
Delete
Click the button if you would like to delete this entry from the list.
To enter an IPv6 Interface into the
IPv6
Static Route
list, click the
Add
button, revealing the following window to configure.
Figure 8- 20. Static/Default Route Settings – Add menu
123