D-Link xStack DGS-3600 Series User Manual - File System Services
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
File System Services
The xStack DGS-3600 switch series contains a 16-megabyte Flash memory where the user may store files for further use on the
Switch. The user may place over 200 re-nameable files on the FAT 16 mode Flash memory, of which the user has the option of
setting firmware images and configuration files as boot up files, upon the next reboot of the Switch.
The Switch automatically assigns default names to the default boot up files located in the flash memory. The default firmware
files is named RUN.HAD while the default boot up configuration file is named STARTUP.CFG. After the system has powered up
or has been reset, the Switch will check the Flash memory for these files. If no corruption or other problems exist on the Flash, the
Switch will use the files set as the boot up files and load them into the Switch. If a problem occurs, the Switch will use the PROM
(programmable read-only memory) will provide the FAT 16 re-building function, which will format the Flash as FAT 16 and
enter the Z-modem download mode where the user will download firmware, saved as RUN.HAD and then boot from this
firmware image.
To configure the files located on the Flash memory, use the following windows to guide you.
System Boot Information
The
System Boot Info Table
is used to view and configure boot up firmware images and configuration files. To set a file as a
boot up file, enter the file name and path into the File Name field under the Boot Image Settings heading and click
Apply
. The
Switch will recognize
.HAD
files as firmware images and
.CFG
files as configuration files when being set as the boot up file.
Newly configured boot up files will be displayed in the
System Boot Info Table
.
Figure 6- 18. System Boot Info Table
FS Information
The FS Information window allows users to view the settings of the Flash Drive in the Switch. This information is read-only and
is just a description of the internal Flash memory.
Figure 6- 19. Media Information
This window offers the following information about the internal Flash Drive.
Parameter
Description
Drive ID
The name of the drive of the memory. There is only one drive in the Flash and it is named
C:
.
Media Type
The type of storage media present in this Switch, which is a Flash memory system.
Size
Denotes the size of the flash memory, which is 16 megabytes.
Label
The label that has been factory set for this Flash memory.
FS Type
The type of File System present in the Switch. For this release, only a FAT16 file system is used
in the Switch.
.
44