D-Link xStack DGS-3600 Series User Manual - Installing The Sfp Ports
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 1- 14. Inserting the optional modules into the Switch.
Now tighten the two screws at adjacent ends of the module into the available screw holes on the Switch. The upgraded DGS-
3627/DGS-3627G/DGS-3650 is now ready for use.
Figure 1- 15. DGS-3627 with optional module installed.
Installing the SFP ports
The xStack DGS-3600 Series switches are equipped with SFP (Small Form Factor Portable) ports, which are to be used with
fiber-optical transceiver cabling in order to uplink various other networking devices for a gigabit link that may span great
distances. These SFP ports support full-duplex transmissions, have auto-negotiation and can be used with the DEM-310GT
(1000BASE-LX), DEM-311GT (1000BASE-SX), DEM-312GT2 (1000BASE-LX), DEM-314GT (1000BASE-LH), DEM-315GT
(1000BASE-ZX), DEM-330T/R (WDM) and DEM-331T/R (WDM)transceivers. See the figure below for installing the SFP ports
in the Switch.
Figure 1- 16. Inserting the fiber-optic transceivers into the DGS-3600 series switch
7