D-Link xStack DGS-3600 Series User Manual - Routing Table
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Routing Table
The Switch supports static routing for IP and IPv6 formatted addressing. Access both menus in the
Routing Table
folder.
Static/Default IP Route Settings
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP forwarding is
accomplished by the entry of an IP address into the Switch’s
Static IP Routing Table
. To view the following window, click
Layer 3 > Routing Table > Static/Default Route Settings
.
Figure 8- 17. Static/Default Route Settings window
This window shows the following values:
Parameter Description
IP Address
The IP address of the Static/Default Route.
Subnet Mask
The corresponding Subnet Mask of the IP address entered into the table.
Gateway
The corresponding Gateway of the IP address entered into the table.
Metric
Represents the metric value of the IP interface entered into the table. This field may read a
number between 1-65535.
Protocol
Represents the protocol used for the Routing Table entry of the IP interface.
Backup State
Represents the Backup state that this IP interface is configured for. This field may read Primary
or Backup.
Delete
Click the button if you would like to delete this entry from the Static/Default Route Settings
table.
To enter an IP Interface into the Switch’s
Static/Default Route Settings
window, click the
Add
button, revealing the following
window to configure.
Figure 8- 18. Static/Default Route Settings – Add window
The following fields can be set:
122