D-Link xStack DGS-3600 Series User Manual - Snmp Traps Settings
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
SNMP Traps Settings
The following window is used to enable and disable trap settings for the SNMP function on the Switch. To view this window for
configuration, click
Administration > SNMP Manager > SNMP Trap Settings
:
Figure 6- 25. SNMP Trap Settings
To enable or disable the Traps State and/or the Authenticate Traps State, use the corresponding pull-down menu to change and
click
Apply
.
SNMP User Table
The
SNMP User Table
displays all of the SNMP User's currently configured on the Switch.
In the
SNMP Manager
folder, located in the
Administration
folder, click on the
SNMP User Table
link. This will open the
SNMP User Table
window, as shown below.
Figure 6- 26. SNMP User Table window
To delete an existing
SNMP User Table
entry, click the
below the Delete heading corresponding to the entry you wish to
delete.
To display the detailed entry for a given user, click on the View button under the Display heading. This will open the
SNMP User
Table Display
window, as shown below.
Figure 6- 27. SNMP User Table Display window
The following parameters are displayed:
Parameter Description
User Name
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
Group Name
This name is used to specify the SNMP group created can request SNMP messages.
SNMP Version
V1
- Indicates that SNMP version 1 is in use.
V2
- Indicates that SNMP version 2 is in use.
V3
- Indicates that SNMP version 3 is in use.
49