D-Link xStack DGS-3600 Series User Manual - Port Access Control
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Port Access Control
The following screens are used to monitor 802.1X statistics of the Switch, on a per port basis. To view the
Port Access Control
screens, open the monitoring folder and click the
Port Access Control
folder. There are six screens to monitor.
NOTE:
The
Authenticator State
cannot be viewed on the Switch unless
802.1X is enabled by port or by MAC address. To enable 802.1X, go to
the DGS-3600 Web Management Tool menu.
Authenticator State
The following section describes the 802.1X Status on the Switch.
To view the Authenticator State, click
Monitoring > Port Access
Control > Authenticator State.
This window displays the
Authenticator State
for individual ports
on a selected device. A polling interval between
1
and
60
seconds
can be set using the drop-down menu at the top of the window and
clicking
OK
.
The information on this window is described as follows:
Parameter Description
Auth PAE
State
The
Authenticator PAE State
value can be:
Initialize, Disconnected, Connecting,
Authenticating, Authenticated, Aborting,
Held, Force_Auth, Force_Unauth,
or
N/A
.
N/A
(Not Available) indicates that the port's
authenticator capability is disabled.
Backend
State
The
Backend Authentication State
can be
Request, Response, Success, Fail, Timeout,
Idle, Initialize,
or
N/A
.
N/A
(Not Available)
indicates that the port's authenticator
capability is disabled.
Port Status
Controlled Port Status can be
Authorized,
Unauthorized,
or
N/A
.
Figure 12- 20. Authenticator State window
253