D-Link xStack DGS-3600 Series User Manual - Ip Interface Settings
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
The amount of broadcast data, such as RIP update packets and PIM hello packets, will be increased.
•
IP Interface Settings
Each VLAN must be configured prior to setting up the VLAN’s corresponding IP interface.
An example is presented below:
VLAN Name
VID
Switch Ports
System (default)
1
5, 6, 7, 8, 21, 22, 23, 24
Engineer
2
9, 10, 11, 12
Marketing
3
13, 14, 15, 16
Finance
4
17, 18, 19, 20
Sales
5
1, 2, 3, 4
Backbone 6 25,
26
Table 8- 1. VLAN Example - Assigned Ports
In this case, six IP interfaces are required, so a CIDR notation of 10.32.0.0/11 (or a 11-bit) addressing scheme will work. This
addressing scheme will give a subnet mask of 11111111.11100000.00000000.00000000 (binary) or 255.224.0.0 (decimal).
Using a 10.xxx.xxx.xxx IP address notation, the above example would give 6 network addresses and 6 subnets. Any IP address
from the allowed range of IP addresses for each subnet can be chosen as an IP address for an IP interface on the Switch. For this
example, we have chosen the next IP address above the network address for the IP interface’s IP Address:
VLAN Name
VID
Network Number
IP Address
System (default)
1
10.32.0.0
10.32.0.1
Engineer 2
10.64.0.0 10.64.0.1
Marketing 3
10.96.0.0 10.96.0.1
Finance 4
10.128.0.0
10.128.0.1
Sales 5
10.160.0.0
10.160.0.1
Backbone 6
10.192.0.0 10.192.0.1
Table 8- 2. VLAN Example - Assigned IP Interfaces
The six IP interfaces, each with an IP address (listed in the table above), and a subnet mask of 255.224.0.0 can be entered into the
IP Interface Settings
window.
To setup IP Interfaces on the Switch:
Go to the
L3 Features
folder, and click on the folder, and then click on the
IP Interfaces Settings
link to open the following
dialog box:
Figure 8- 1. IP Interface Table window
To setup a new IP interface, click the
Add
button. To edit an existing IP Interface entry, click on an entry under the
Interface
Name
heading. Both actions will result in the same screen to configure, as shown below.
111