D-Link xStack DGS-3600 Series User Manual - Tftp Services
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
TFTP Services
Figure 6- 17. TFTP Services window
Trivial File Transfer Protocol (TFTP) services allow
the Switch's firmware to be upgraded by transferring
a new firmware file from a TFTP server to the
Switch. A configuration file can also be loaded into
the Switch from a TFTP server. Switch settings can
be saved to the TFTP server, and a history log can be
uploaded from the Switch to the TFTP server. The
TFTP server must be running TFTP server software
to perform the file transfer.
The user also has the option of transferring firmware and configuration files to and from the internal Flash drive, located on the
Switch. Using this window, the user can add a configuration or firmware file from a TFTP server to the flash memory, or transfer
that firmware or configuration file to a TFTP server. More about configuring the internal Flash drive can be found in the next
section entitled
Flash File Services
.
TFTP server software is a part of many network management software packages – such as NetSight, or can be obtained as a
separate program
.
To update the Switch's firmware or configuration file, open the
TFTP Services
hyperlink, located in the
Administration
folder.
The following parameters can be configured:
Parameter Description
Active
Select a service for the TFTP server to perform from the drop down window:
•
•
•
•
Download Firmware
- Enter the IP address of the TFTP server and specify the
location of the new firmware on the TFTP server. Click
Start
to record the IP
address of the TFTP server and to initiate the file transfer.
Download Configuration
- Enter the IP address of the TFTP server, and the path
and filename for the Configuration file on the TFTP server. Click
Start
to record the
IP address of the TFTP server and to initiate the file transfer.
Upload Configuration
- Enter the IP address of the TFTP server and the path and
filename for the switch settings on the TFTP server. Click
Start
to record the IP
address of the TFTP server and to initiate the file transfer.
Upload Log
- Enter the IP address of the TFTP server and the path and filename
for the history log on the TFTP server. Click
Start
to record the IP address of the
TFTP server and to initiate the file transfer.
Server IP Address
Enter the IP address of the server from which to download firmware or configuration files.
Local File Name
Enter the path and filename of the firmware or configuration file to upload or download, located
on the TFTP server.
Image File in Flash
To select a firmware file from the internal Flash drive to be transferred, or to load a firmware file
on to the Flash drive, enter the path and filename here and click the corresponding check box.
Remember, the only path that can be used on the flash is named C:/. (ex. c:/runtime.had)
Configuration File
in Flash
To select a configuration file from the internal Flash drive to be transferred, or to load a
configuration file on to the Flash drive, enter the path and filename here and click the
corresponding check box. Remember, the only path that can be used on the flash is named
C:/. (ex. c:/configuration.had)
Click
Start
to initiate the file transfer.
43