D-Link xStack DGS-3600 Series User Manual - Static Vlan Entry
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Protocol
IP over Ethernet
0x0800
IPX 802.3
IPX 802.2
Type Header in Hexadecimal Form
0xFFFF
0xE0E0
IPX SNAP
0x8137
IPX over Ethernet2
0x8137
decLAT 0x6004
SNA 802.2
0x0404
netBios 0xF0F0
XNS 0x0600
VINES 0x0BAD
IPV6 0x86DD
AppleTalk 0x809B
RARP 0x8035
SNA over Ethernet2 0x80D5
Table 6- 1. Protocol VLAN and the corresponding type header
In configuring the user-defined protocol, the administrator must make sure that the pre-defined user type header does not match
any other type header. A match may cause discrepancies within the local network and failure to define the VLAN to forward
packets to.
Static VLAN Entry
In the
L2 Features
folder, click
VLAN > Static VLAN Entry
to open the following window:
Figure 7- 6. Current 802.1Q Static VLANs Entries window
The
Current
802.1Q Static VLAN Entries
window lists all previously configured VLANs by VLAN ID and VLAN Name. To
delete an existing 802.1Q VLAN, click the corresponding button under the
Delete
heading.
To create a new 802.1Q VLAN, click the
Add
button in the
802.1Q Static VLANs
window. A new window will appear, as
shown below, to configure the port settings and to assign a unique name and number to the new VLAN. See the table below for a
description of the parameters in the new window.
78